When using gas generator set, pay attention to the use of supercharger:

　　增压器工作在高速、高温、高速、高温、低温条件下。涡轮进口温度可高达650°，额定转速为27500r/min。

　　The supercharger works at high speed, high temperature, high speed, high temperature and low temperature. The turbine inlet temperature can be as high as 650 ° and the rated speed is 27500r / min.

　　1. 对于新使用或维修过的增压器，在安装前应使用手动转子检查转子的转动情况。正常情况下，转子应轻、灵活、无干扰、无异常声音;

　　1. For the newly used or repaired supercharger, the manual rotor shall be used to check the rotation of the rotor before installation. Under normal conditions, the rotor shall be light, flexible, without interference and abnormal sound;

　　2. 连接润滑管路，保持润滑油路畅通，采用浮动轴承，对润滑油要求高，工作正常，油压应保持在300kpa至500kPa之间，发动机怠速时，增压器油压不应低于80kPa;

　　2. Connect the lubricating pipeline, keep the lubricating oil pipeline unblocked, adopt floating bearing, have high requirements for lubricating oil, work normally, keep the oil pressure between 300kPa and 500kPa, when the engine is idling, the oil pressure of supercharger shall not be less than 80kPa;

　　3.发动机启动后，注意增压器入口的压力。压力必须在3秒内显示出来。否则增压器会因缺乏润滑油而烧坏。

　　3. After the engine is started, pay attention to the pressure at the supercharger inlet. The pressure must be displayed in 3 seconds. Otherwise, the supercharger will burn out due to lack of lubricating oil.

　　4. 增压器的涡轮壳处于高温状态，操作人员应注意避免高温烫伤。

　　4. The turbocharger's turbine shell is in high temperature state, and the operator should pay attention to avoid high temperature scald.

　　5. 调节压力调节阀时，逆时针旋转以降低压力，顺时针旋转以增加压力。

　　5. When adjusting the pressure regulating valve, turn it anticlockwise to reduce the pressure and clockwise to increase the pressure.

　　以上是瓦斯发电机组厂家为大家介绍的相关内容，想要了解更多内容，欢迎访问网站:http://www.huannengpower.com

　　The above is the related content introduced by the manufacturer of gas generator set. For more information, please visit the website: http://www.huannengpower.com