欢迎进入济南济柴环能燃气发电设备有限公司官网!
当前位置:首页 - 新闻中心 - 行业资讯

行业资讯

燃气发电机组三方面的安全操作事项

返回 2022.09.27 来源:http://www.huannengpower.com
燃气发电机组被使用越来越广泛,操作不当也是很容易发生意外的,所以我们在使用燃气发电机组的时候要特别小心注意,建议是人操作。下面小编来讲讲燃气发电机组三方面的安全操作事项。
Gas generator sets are used more and more widely, and accidents are easy to occur if they are not operated properly. Therefore, we should pay special attention when using gas generator sets, and it is recommended that they be operated by professionals. The following section will talk about three aspects of safe operation of gas generator unit.
1、启动前的准备:
1. Preparation before startup:
启动前先检查调整好整个机组的状况,各个组件的连接及固定须可靠无误,发动机的冷却水系,电启动系统都连接可靠,不滴漏、不松脱,开关灵活,润滑系良好,燃气供给系以及点火系都确认正常,否则要立即检修、调整正确方可启动。
Before starting, check and adjust the condition of the whole unit. The connection and fixation of each component must be reliable. The cooling water system and electric starting system of the engine must be connected reliably without leakage or looseness. The switch is flexible, the lubrication system is in good condition, and the gas supply system and ignition system are confirmed to be normal. Otherwise, the engine can be started only after the maintenance and adjustment are correct.
2、启动后的怠速运行:
2. Idle running after startup:
一切准备正常后,打开燃气阀门,接上启动电源,打开钥匙,按下按钮,就可启动机组。当机组启动后,马上注意机油压力表,一定保证有正常的机油压力,万万不可粗心大意。
After everything is ready, open the gas valve, connect the startup power, open the key, and press the button to start the unit. When the unit is started, pay attention to the oil pressure gauge immediately to ensure normal oil pressure and never be careless.
启动后要怠速运行一段时间,一是用以观察各处、各部件的运行情况是否异常,有无异常声响,有问题马上处理、解决。怠速运转也是用来使机器升温,特别是冬季,这升温是十分要的,将非常有利于机器的使用。
After startup, it is required to operate at idle speed for a period of time. First, it is used to observe whether the operation of various parts and components is abnormal and whether there is abnormal sound. If there is any problem, it should be solved immediately. Idle running is also used to heat up the machine, especially in winter, which is very important and will be very conducive to the use of the machine.
燃气发电机组
3、正常的负载输出:
3. Normal load output:
当经怠速观察,且机组已达到了一定的温度(观察水温表即可)就可以操纵电调“油门”将机组升速到标定的工作转速,调整机组的电压和频率都达到标定值,则可向外界合闸,输出负载。为了保证合闸时外界有负载使用,建议合闸前交将空车的转速(频率)稍稍偏高些。负载变化时,注意调速“油门”手柄,即电子调速器的电位器,适应输出,保证电压和频率的稳定。
When the idle speed is observed and the unit has reached a certain temperature (just observe the water temperature gauge), you can control the electric regulating "throttle" to speed up the unit to the calibrated working speed. Adjust the voltage and frequency of the unit to reach the calibrated value, then you can switch on to the outside and output the load. In order to ensure that the external load is used when closing, it is recommended that the speed (frequency) of the empty car be slightly higher before closing. When the load changes, pay attention to the speed regulating "throttle" handle, that is, the potentiometer of the electronic governor, to adapt to the output and ensure the stability of the voltage and frequency.
此外、燃气发电机组机房内应符合消防要求,配备灭火器等消防器械;机房内安装可燃气体报警装置,可燃气体泄露时能及时发现。安全为重,大家使用该设备要上心。更多注意事项来我们网站http://www.huannengpower.com咨询。
In addition, the engine room of the gas generator unit shall meet the fire protection requirements and be equipped with fire extinguishers and other fire-fighting equipment; Combustible gas alarm device shall be installed in the machine room to detect the leakage of combustible gas in time. Safety is the most important. Everyone should be careful when using this equipment. Please visit our website for more precautions http://www.huannengpower.com consulting service
新闻搜索
济南济柴环能燃气发电设备有限公司
  • 服务热线

    0531-62325028
    0531-69951266

燃气发电机组三方面的安全操作事项

燃气发电机组被使用越来越广泛,操作不当也是很容易发生意外的,所以我们在使用燃气发电机组的时候要特别小心注意,建议是人操作。下面小编来讲讲燃气发电机组三方面的安全操作事项。
Gas generator sets are used more and more widely, and accidents are easy to occur if they are not operated properly. Therefore, we should pay special attention when using gas generator sets, and it is recommended that they be operated by professionals. The following section will talk about three aspects of safe operation of gas generator unit.
1、启动前的准备:
1. Preparation before startup:
启动前先检查调整好整个机组的状况,各个组件的连接及固定须可靠无误,发动机的冷却水系,电启动系统都连接可靠,不滴漏、不松脱,开关灵活,润滑系良好,燃气供给系以及点火系都确认正常,否则要立即检修、调整正确方可启动。
Before starting, check and adjust the condition of the whole unit. The connection and fixation of each component must be reliable. The cooling water system and electric starting system of the engine must be connected reliably without leakage or looseness. The switch is flexible, the lubrication system is in good condition, and the gas supply system and ignition system are confirmed to be normal. Otherwise, the engine can be started only after the maintenance and adjustment are correct.
2、启动后的怠速运行:
2. Idle running after startup:
一切准备正常后,打开燃气阀门,接上启动电源,打开钥匙,按下按钮,就可启动机组。当机组启动后,马上注意机油压力表,一定保证有正常的机油压力,万万不可粗心大意。
After everything is ready, open the gas valve, connect the startup power, open the key, and press the button to start the unit. When the unit is started, pay attention to the oil pressure gauge immediately to ensure normal oil pressure and never be careless.
启动后要怠速运行一段时间,一是用以观察各处、各部件的运行情况是否异常,有无异常声响,有问题马上处理、解决。怠速运转也是用来使机器升温,特别是冬季,这升温是十分要的,将非常有利于机器的使用。
After startup, it is required to operate at idle speed for a period of time. First, it is used to observe whether the operation of various parts and components is abnormal and whether there is abnormal sound. If there is any problem, it should be solved immediately. Idle running is also used to heat up the machine, especially in winter, which is very important and will be very conducive to the use of the machine.
燃气发电机组
3、正常的负载输出:
3. Normal load output:
当经怠速观察,且机组已达到了一定的温度(观察水温表即可)就可以操纵电调“油门”将机组升速到标定的工作转速,调整机组的电压和频率都达到标定值,则可向外界合闸,输出负载。为了保证合闸时外界有负载使用,建议合闸前交将空车的转速(频率)稍稍偏高些。负载变化时,注意调速“油门”手柄,即电子调速器的电位器,适应输出,保证电压和频率的稳定。
When the idle speed is observed and the unit has reached a certain temperature (just observe the water temperature gauge), you can control the electric regulating "throttle" to speed up the unit to the calibrated working speed. Adjust the voltage and frequency of the unit to reach the calibrated value, then you can switch on to the outside and output the load. In order to ensure that the external load is used when closing, it is recommended that the speed (frequency) of the empty car be slightly higher before closing. When the load changes, pay attention to the speed regulating "throttle" handle, that is, the potentiometer of the electronic governor, to adapt to the output and ensure the stability of the voltage and frequency.
此外、燃气发电机组机房内应符合消防要求,配备灭火器等消防器械;机房内安装可燃气体报警装置,可燃气体泄露时能及时发现。安全为重,大家使用该设备要上心。更多注意事项来我们网站http://www.huannengpower.com咨询。
In addition, the engine room of the gas generator unit shall meet the fire protection requirements and be equipped with fire extinguishers and other fire-fighting equipment; Combustible gas alarm device shall be installed in the machine room to detect the leakage of combustible gas in time. Safety is the most important. Everyone should be careful when using this equipment. Please visit our website for more precautions http://www.huannengpower.com consulting service
下一篇:最后一页