Summer rain is more, if there is no diesel generating set well waterproof measures, will cause the rain from the pipe into the engine cylinder block or power ball, affect the operation and service life of the unit. Therefore, when the unit is flooded, the following measures should be taken as follows:
When the generator is in the water, if the generator is running, it will be turned off immediately.
2, will prop up one side of the diesel generator set with hard objects, make the engine oil sump oil drain parts in the lowest position, spin down the oil plug, pull out the oil scale, make themselves out of the water in the oil sump. When the flow of oil is to be released, the oil and water should be released a little bit to release the oil screw.
Remove the air filter, replace the new filter and soak in oil.
Remove the incoming, exhaust pipe and silencer, and remove the water from the tube. Open decompression, rocking-turn diesel power generation, observe whether there is water inlet and outlet, if there is water continues to turn the crankshaft, net to all of the water in the cylinder. Fill in, exhaust pipe and muffler, add a little oil to the inlet, roll the crank shaft several times, then install air filter.
Remove the fuel tank, remove all the oil and water, check for water and drain the fuel system.
Discharge water from water tanks and waterways, clean waterways, add clean water or boil water to the water float. Turn on the throttle switch and start the diesel engine. When the diesel engine starts up, watch the engine oil indicator rise and listen to the engine without any noise.
Disassemble the generator, check the stator and rotor inside the generator and then reassemble after drying.
Our company will abide by the commercial reputation and the principle of equality and mutual benefit, we sincerely provide users with the most excellent service to create a more perfect work, sincere hope and friends from all walks of life hand in hand advances boldly, create prosperity.