你好,欢迎来到济南济柴环能燃气发电设备有限公司官方网站!

正确的解决柴油发电机组漏水问题

来源:http://www.huannengpower.com   发布于:2017-01-21

  柴油发电机组的“三漏”故障指:柴油发电机组漏水、漏机油、漏柴油。“漏水”主要表现在淡水泵、水散热器、水管漏水;“漏机油”主要表现在油底壳垫片漏油;“漏柴油”主要表现在输油泵和柴油滤清器各接口部位漏柴油。以下是各部件漏水、漏机油、漏柴油的解决方法:

  The "three leakage" fault of diesel generator sets is the leakage, leakage and leakage of diesel engine. "Water Leakage" mainly Water Leakage in fresh water pump, radiator, water pipe; leak oil mainly in the oil pan gasket leakage; leakage of diesel mainly in the oil pump and the interface part of diesel diesel filter leakage. The following are the components of leakage, leakage of oil, diesel leakage solution:

  1、柴油发电机组漏水的处理方法:

  1, diesel generator set leakage treatment method:

  (1)淡水泵漏水解决方法:淡水泵漏水的解决方法若淡水泵监视孔也出现漏水,应从机体上拆下淡水泵并进行分解,然后更换水封。淡水泵上安装的放水阀由于弹簧损坏而漏水时,可以更换新弹簧或新放水阀。维护人员要在放水阀的弹簧上涂上润滑脂,以防止弹簧生锈。

  (1) fresh water pump Water Leakage solutions: if the water pump water pump Water Leakage sightglass Water Leakage also appeared on the body, we should remove the water pump and decomposed, and then replace the water. When the water discharge valve installed on the fresh water pump is leaking due to the damage of the spring, the utility model can replace a new spring or a new water discharge valve. Maintenance personnel should be on the drain valve spring coated with grease to prevent the spring rust.

  (2)水散热器漏水的解决方法:散热器上、下水室的修理方法检测出散热器漏水的部位后,要将漏水的部位清洗干净,再用金属刷或刮刀彻底清除金属漆和铁锈,然后用焊锡修补。若上、下水室的固定螺钉部位出现较大面积的漏水现象,可以拆下上、下水室,然后重新制作两个大小适当的水室。装配上、下水室前要在密封垫的上、下面涂上黏结剂或密封胶,再有螺钉进行固定。

  (2) solution: detect the Water Leakage water radiator radiator parts repair method Water Leakage radiator water room, after cleaning the site will Water Leakage clean, then the metal brush or scraper to completely remove the metallic paint and rust, and then use the soldering repair. If the upper and lower parts of the fixed screw parts of a larger area of water leakage phenomenon, you can remove the upper and lower chamber, and then re production of two appropriate size of the water chamber. Before assembling the upper and lower water chamber, apply the adhesive or sealant on the gasket, and then fix the screws.

  散热器水管的修理方法在检测过程上发现散热器的外层水管破损面积较小时,可使用锡焊进行修复。若破损部位较大,可用尖嘴钳把破损管的两边管头夹死,使之不漏水。但堵塞水管的数量不宜过多,否则会影响散热器的散热效果。若散热器的内部水管出现破损现象,则尖将上、下水室拆下后,更换或焊补散热器的内部水管。

  Repair method of radiator pipe outer pipe radiator found damaged area is small in the detection process, can be used to repair soldering. If the damaged parts of large broken pipe clamp available on both sides of the tube head clamp die, so that it is not Water Leakage. However, the number of clogged pipes should not be too much, otherwise it will affect the heat sink. If the radiator of the internal water pipe damage phenomenon, then the tip of the upper and lower water chamber removed, replace or repair the radiator water pipe.

  (3)水管漏水的解决方法水管由于老化而出现漏水时,一是应更换新管。若水管难以买到,可用防水胶布进行缠绕。若由于卡子锈蚀而出现漏水时,可更换卡子或用铁丝进行缠绕。二是柴油发电机组油底壳垫片漏油的解决方法从油底壳垫片处漏机油时,应更换垫片。

  (3) the method to solve the problem of water leakage of water pipes, due to aging and leakage, one is to replace the new pipe. If it is difficult to buy water available waterproof tape winding. If the clip corrosion and leakage occurs, you can replace the clip or wire winding. Two is the diesel generator set oil sump gasket leakage solution from the oil sump gasket leak oil, should replace the gasket.

  2、更换油底壳垫片的方法如下:用套筒扳手或梅花扳手按对角全部拆下油底壳固定螺钉。拆下后要擦净油底壳和曲轴箱与垫片接触的部分,然后涂上密封胶,把垫片安整齐后进行装配。在装配过程中要按对角拧上螺钉,不要一个螺钉审批权紧后再拧紧第二个。待所有螺钉拧上后,再逐步将所有螺钉按技术要求拧紧。

  2, the replacement of oil pan gasket method is as follows: the use of socket wrench or spanner wrench all the oil off the bottom of the fixed screws. Remove the oil pan and the contact part between the crankcase and the gasket after removing, and then apply the sealant to the gasket. Screw the screws in the process of assembly, do not tighten the screws and tighten the second screws. After all screws are screwed on, then gradually tighten all screws according to the technical requirements.

  3、柴油发电机组输油泵和柴油滤清器各接口部位漏柴油的解决方法接口部位漏柴油的故障一般都是由于垫片损坏或回油螺钉松动所造成的,若是由于回油螺钉松动所致,只要维修人员用梅花扳手按规定扭矩将其拧紧即可。

  Fault solution interface part 3, diesel generator fuel pump and fuel filter the interface part of diesel diesel oil leakage leakage is generally because the gasket is damaged or screw loosening caused by the oil, if the oil return screw loosening caused by maintenance personnel, as long as with plum blossom wrench torque required to tighten it.

  客户的满意就是对我们的肯定,欢迎您前来选购我公司的产品,我们一直以为您提供产品为己任并一直坚持这样做。欢迎您的光临。

  Customer satisfaction is our affirmation, welcome you to come to buy my company's products, we have always thought that you provide products as their own responsibility and has always insisted on doing so. Welcome your presence.


上一篇:燃气发电机组润滑方式有几种
下一篇:沼气发电机组起励失败的缘故为什么会产生噪音