你好,欢迎来到济南济柴环能燃气发电设备有限公司官方网站!

燃气发电机组启动后转速使用注意

来源:http://www.huannengpower.com   发布于:2017-07-14

燃气发电机组使用中需要注意事项:

Attentions to be used in gas generator set:

1、机房应远离明火区域;

1, the engine room should be far away from the open flame area;

2、机房应宽敞、明亮且要求安装换气扇保证良通风;

2, the room should be spacious, bright and ensure good ventilation fan installation requirements;

3、产品安装底盘与基应用平垫铁找平接触面积应60%且布均匀;

3, product installation chassis and base application pad, iron leveling contact area should be 60% and cloth evenly;

4、室内安装照明、关、线路及其电器应采用防爆措施,且固定牢固;

4, indoor installation lighting, customs, wiring and electrical appliances should be explosion-proof measures, and fixed firm;

燃气发电机组

5、燃气发电机组机房内应符合消防要求配备灭火器等消防器械;

5, gas generator room should comply with fire requirements, equipped with fire extinguishers and other fire appliances;

6、燃气发电机组机房内安装燃气体报警装置燃气体泄露能及发现;

6, gas generator room installed gas alarm device, gas leakage, energy and discovery;

7、60kw单台燃气发机燃气管路外部主要管道内径应于2吋靠近发机部内径应于1吋60kw燃气发电机组则别3吋两吋且必须安装燃气阀门、型放水阀、防火装置燃气管路焊接完应清理焊渣。

7, 60kW single gas engine gas pipeline outside the main pipe diameter should be 2 inches in diameter should be close to the machine, 1 inch 60kW gas turbines are not 3 inches two inches and must be installed in the gas valve, drain valve, fire protection device type gas pipeline welding end should clean welding slag.

燃气发电机组启动后转速升不上去:

After the gas generator starts, the speed can not rise:

1、燃料气压力低或预燃室阀不工作。检查燃料气压力及阀门开度,如果压力低,缓慢提高压力;如果压力正常,检查预燃室电磁阀的工作及系统管路漏失情况。

1, the fuel gas pressure is low or the precombustion chamber valve does not work. Check the fuel gas pressure and valve opening, if the pressure is low, slowly increasing the pressure; if the pressure is normal, and the pipeline inspection system precombustion chamber solenoid valve leakage situation.

2、空气量不够。检查空气滤清器的进出压差,如果超标,需更换滤芯。检查空气管路漏失情况。检查涡轮增压器转子运转情况。

2, the amount of air is not enough. Check air filter inlet and outlet pressure difference, if exceed standard, need to change filter core. Check air pipe leakage. Check the operation of the turbocharger rotor.

3、调速器不工作。调速器不动作的原因是混合器蝶阀开度不够,调整或更换。

3 、 governor does not work. The governor does not move because the butterfly valve of the mixer is not open enough to adjust or replace.

4、动力缸温差大,多个缸不点火。清洁火花塞及点火线圈,保证气体干燥并接触良好。检查预燃室进气阀的工作情况,清除积炭,使阀芯开闭灵活。

4 、 the temperature difference between the power cylinder is large, and the multiple cylinders do not ignite. Clean spark plugs and ignition coils to keep the gas dry and in good contact. Work, check the precombustion chamber of the intake valve to remove coke, so that the valve opening and closing flexible.

5、空燃比控制阀步进电机发卡。切断电源,将其拆下清洁。然后装好线束,送电检查其工作情况,调整正常后将其装回。

5, air fuel ratio control valve, stepper motor card. Cut off the power supply and clean it. Then install the wiring harness, send the electricity, check its work, adjust the normal, and install it back.

6、混合器故障。混合器漏失或阀芯膜片破损或造成阀芯无法正常工作,影响燃料气的供给。整漏,清洁阀芯以及检查膜片燃气发电机组。

6 mixer malfunction. Mixer leakage or spool diaphragm damage or spool valve can not work properly, affecting the supply of fuel gas. Whole leakage, cleaning valve core and checking diaphragm gas generator set.

我们拥有严谨的工作态度,熟练的工作技能,将确保任务准确、高效的完成。

We have a strict work attitude, skilled work skills, will ensure that the task is accurate and efficient completion.


上一篇:瓦斯发电机组空气滤清器
下一篇:变速箱油的作用及不按时换油的危害