欢迎进入济南济柴环能燃气发电设备有限公司官网!

常见问题解答

燃气发电机组充不进去电的原因

返回 2022.09.16 来源:http://www.huannengpower.com 0
现在市场上卖燃气发电机组的厂家越来越多,其实很多都是中间商,所以燃气发电机组故障售后一般都很难去解决,这也让很多客户都是非常感慨的。比如燃气发电机组充不进去电,下面就来讲讲这个问题。
Now there are more and more manufacturers selling gas generator sets in the market. In fact, many of them are middlemen, so it is generally difficult to solve the after-sales problems of gas generator sets, which also makes many customers very emotional. For example, the gas generator set cannot be charged with electricity, so let's talk about this problem.
小编认为燃气发电机组充不了电有可能是保险丝或整流二极管损坏所造成的。当保险丝烧断后,充电机电源指示灯不亮;整流二极管损坏后,充电机的电源指示灯亮,但无直流电输出,其原因可能:
I think that the failure of gas generator set to charge may be caused by the damage of fuse or rectifier diode. When the fuse is burnt out, the charger power indicator does not light up; After the rectifier diode is damaged, the power indicator of the charger is on, but there is no DC output. The causes may be:
1、充电机变压器被烧坏。
1. The charger transformer is burnt out.
2、充电机上的二极管被烧坏。
2. The diode on the charger is burnt out.
燃气发电机组
3、充电机的充电电流表损坏。
3. The charging ammeter of the charger is damaged.
4、充电机的保险丝被烧坏。
4. The fuse of the charger is burnt out.
解决方法:断开充电机与蓄电池的连接线,用万用表直流电压挡(50V)测试充电机两个输出接线柱间的电压,注意红表笔接充电机的正极,黑表笔接负极,发现无电压输出。
Solution: Disconnect the connecting wire between the charger and the battery, and use a multimeter DC voltage gear (50V) to test the voltage between the two output terminals of the charger. Note that the red probe is connected to the positive pole of the charger, and the black probe is connected to the negative pole. It is found that there is no voltage output.
拆下充电机外壳,对充电保险芯子进行检查,发现60A的保险芯子烧坏。
Dismantle the charger housing and check the charging fuse core. It is found that the 60A fuse core is burnt out.
更换后,充电机恢复正常充电,故障即被排除。
After replacement, the charger will resume normal charging, and the fault will be eliminated.
以上就是关于燃气发电机组充不了电的原因和解决方法,您对此有什么不了解的地方,可以随时来我们网站http://www.huannengpower.com进行咨询。
The above is about the reasons and solutions for the failure of gas generator set to charge. If you have any questions about this, you can come to our website at any time http://www.huannengpower.com Consult.
新闻搜索
济南济柴环能燃气发电设备有限公司
  • 服务热线

    0531-62325028
    0531-69951266

燃气发电机组充不进去电的原因

现在市场上卖燃气发电机组的厂家越来越多,其实很多都是中间商,所以燃气发电机组故障售后一般都很难去解决,这也让很多客户都是非常感慨的。比如燃气发电机组充不进去电,下面就来讲讲这个问题。
Now there are more and more manufacturers selling gas generator sets in the market. In fact, many of them are middlemen, so it is generally difficult to solve the after-sales problems of gas generator sets, which also makes many customers very emotional. For example, the gas generator set cannot be charged with electricity, so let's talk about this problem.
小编认为燃气发电机组充不了电有可能是保险丝或整流二极管损坏所造成的。当保险丝烧断后,充电机电源指示灯不亮;整流二极管损坏后,充电机的电源指示灯亮,但无直流电输出,其原因可能:
I think that the failure of gas generator set to charge may be caused by the damage of fuse or rectifier diode. When the fuse is burnt out, the charger power indicator does not light up; After the rectifier diode is damaged, the power indicator of the charger is on, but there is no DC output. The causes may be:
1、充电机变压器被烧坏。
1. The charger transformer is burnt out.
2、充电机上的二极管被烧坏。
2. The diode on the charger is burnt out.
燃气发电机组
3、充电机的充电电流表损坏。
3. The charging ammeter of the charger is damaged.
4、充电机的保险丝被烧坏。
4. The fuse of the charger is burnt out.
解决方法:断开充电机与蓄电池的连接线,用万用表直流电压挡(50V)测试充电机两个输出接线柱间的电压,注意红表笔接充电机的正极,黑表笔接负极,发现无电压输出。
Solution: Disconnect the connecting wire between the charger and the battery, and use a multimeter DC voltage gear (50V) to test the voltage between the two output terminals of the charger. Note that the red probe is connected to the positive pole of the charger, and the black probe is connected to the negative pole. It is found that there is no voltage output.
拆下充电机外壳,对充电保险芯子进行检查,发现60A的保险芯子烧坏。
Dismantle the charger housing and check the charging fuse core. It is found that the 60A fuse core is burnt out.
更换后,充电机恢复正常充电,故障即被排除。
After replacement, the charger will resume normal charging, and the fault will be eliminated.
以上就是关于燃气发电机组充不了电的原因和解决方法,您对此有什么不了解的地方,可以随时来我们网站http://www.huannengpower.com进行咨询。
The above is about the reasons and solutions for the failure of gas generator set to charge. If you have any questions about this, you can come to our website at any time http://www.huannengpower.com Consult.