你好,欢迎来到济南济柴环能燃气发电设备有限公司官方网站!

发电机组小故障你也可以搞定!

来源:http://www.huannengpower.com   发布于:2019-04-19

节温器损坏

Damage of thermostat

发电机如果出现水温如过高的现象,一般是由于节温器失效的缘故,致使冷却液大循环流速减慢,需要购买新的节温器进行替换。

If the water temperature of the generator is too high, it is usually due to the failure of the thermostat, which slows down the large circulation velocity of the coolant, so it is necessary to buy a new thermostat to replace it.

1。扇皮带开裂的解决方

1. Solution to Cracking of Fan Belt

发电机的电扇皮带损坏,应立即停机进行替换。假如当下没有条件更行替换,能够将原电扇皮带的断口两头钻两个小孔,再用粗金属丝把断皮带衔接进来做应急运用。需求留意的是,钻孔和断面间应保存恰当的间隔,防止将孔拉裂,金属丝的接头应留在皮带的外侧,皮带不要调的过紧。假如电扇皮带损坏较严峻无法衔接,能够把绳子或布带、牛皮带用铁丝扎紧,编制成一根暂时运用的皮带。格外要留意长短和粗细应与原皮带持平,绳头应当夹在中心绑好。 3、散热器水管漏水

If the fan belt of the generator is damaged, it should be stopped immediately and replaced. If there is no condition for replacement, two small holes can be drilled at both ends of the original fan belt fracture, and then the broken belt can be connected by thick wire for emergency use. It should be noted that proper intervals should be maintained between drilling holes and sections to prevent holes from being pulled apart. The metal wire joints should be left on the outside of the belt and the belt should not be adjusted too tightly. If the fan belt is severely damaged and can not be connected, the rope or cloth belt and cow belt can be tightened with iron wire to weave into a temporary belt. Special attention should be paid to the length and thickness of the belt should be equal to the original belt, and the rope head should be tied in the center. 3. Leakage of radiator water pipe

QQ截图20171025151917.jpg

发电机的使用过程中,散热器水管内部的水温过高,外部的温度过低。或是因为发电机组的震荡,很容易造成水箱的水管漏水的现象。发电机组的水箱漏水可以把散烟丝放入水箱内,利用水循环的压力,来使烟丝堵塞在散热管的漏水处以便暂时运用。假如水箱散热管漏水状况较严峻,能够把漏水处剪断,再把棉花团涂上番笕者在被剪断的散热管处,再用钳子把被剪断的散热管的头部夹扁,再卷边压紧即可止住漏水状况。

During the use of the generator, the water temperature inside the radiator pipe is too high and the temperature outside is too low. Or because of the oscillation of the generator set, it is easy to cause the leakage of water pipes in the water tank. Water leakage in the water tank of the generating unit can put the loose tobacco into the water tank, and make use of the pressure of water circulation to make the tobacco blocked in the leakage of the radiator pipe for temporary use. If the leakage of radiator pipe in water tank is serious, it can cut off the leak, then apply cotton ball on the cut radiator pipe, then use pliers to clamp the head of the cut radiator pipe flat, and then roll the edge and press tightly to stop the leakage.

水泵漏水

Water pump leakage

发电机使用铝水泵,有时会出现密封不严的现象。应当把水封平面修磨平坦,或者把水封翻转180°再安装运用。假如止推橡皮圈损坏、胀大变形、绷簧弹力缺乏、折断等,都应当予以替换,并且在安装时牢记不要将绷簧压死。

Aluminum pump is used in generator, sometimes the seal is not tight. The water seal surface should be grinded flat, or the water seal should be reversed 180 degrees before installation and application. If the thrust rubber ring is damaged, inflated and deformed, the tension spring lacks elasticity, breaks and so on, it should be replaced, and when installing, remember not to press the tension spring to death.

本文的精彩内容由燃气发电机组提供知识提供,本网站还有很多的精彩内容,更多的内容您可以点击进入:http://www.huannengpower.com 我们有专门的客服为您解答问题

The excellent content of this article is provided by the knowledge of gas generating units. There are many wonderful content on this website. You can click on more content to enter: http://www.huannengpower.com. We have a special customer service to answer your questions.


上一篇:哪些原因造成了发电机组的“漏油”?
下一篇:沼气发电机组各部位的结构特点