你好,欢迎来到济南济柴环能燃气发电设备有限公司官方网站!

燃气发电机组日常要避免的事项

来源:http://www.huannengpower.com   发布于:2018-02-07

1、燃气发电机组机房应远离明火区域;

1. The engine room of the gas generator set should be far away from the open fire area.

2、燃气发电机组机房应宽敞、明亮且要求安装换气扇以保证良好的通风;

2, gas generator room should be bright and spacious, require the installation of ventilator to ensure good ventilation;

3、燃气发电机组安装时底盘与地基应用平垫铁找平。接触面积应在60%以上,且分布均匀;

3. When the gas generating set is installed, the base plate and the foundation are leveled with the flat iron. The contact area should be more than 60%, and the distribution is uniform.

4、室内安装照明、开关、线路及其电器应采用防爆措施,且固定牢固;

4, indoor installation of lighting, switches, lines and electrical appliances should be used explosion-proof measures, and fixed firmly;

QQ截图20171025151731.jpg

5、燃气发电机组机房内应符合消防要求,配备灭火器等消防器械;

5. The engine room of the gas generator set should meet the requirements of fire fighting and equipped with fire extinguisher and other fire-fighting instruments.

6、燃气发电机组机房内安装可燃气体报警装置,可燃气体泄露时能及时发现;

6. A combustible gas alarm device is installed in the engine room of a gas generator set, which can be found in time when combustible gas is leaked.

7、60kw以下单台燃气发动机燃气管路的外部主要管道内径应不小于2吋,靠近发动机的部分内径应不小于1吋!60kw以上燃气发电机组则分别是3吋和两吋。且必须安装燃气阀门(不锈钢球阀)、型放水阀、防回火装置,燃气管路焊接完成应清理焊渣(用高压空气);

7. The inner diameter of the main pipe of the gas line of a single gas engine under 60kW should not be less than 2 inches, and the inner diameter of the engine near the engine should not be less than 1 inches. The gas generating units above 60kW are 3 and two inches, respectively. And must install gas valve (stainless steel ball valve), type water release valve, anti tempering device, gas pipeline welding finish should clean welding slag (with high pressure air);

8、燃气必须脱硫、脱水、除尘,其中含流量≤0.25Nm3,氢气≤10%。

8, gas desulfurization, dehydration, to dust, including the flow of hydrogen is less than or equal to 0.25Nm3, less than 10%.


上一篇:生物质气化发电技术的知识介绍
下一篇:柴油发电机组发动机的组成