In order to protect the normal power generation of the generator set, the coking generator set manufacturer reminds everyone to pay attention to the use of the voltage regulator.

　　1.在启动之前，应该断开所有输出开关。

　　1. All output switches should be disconnected before starting.

　　2.将速度提高到额定速度，将端子电压提高到额定电压。观察其稳定性。加载后原动机速度可能发生变化，频率可能低于额定频率。原动机的速度可以再次调整到额定频率。

　　2. Increase speed to rated speed and terminal voltage to rated voltage. Observe its stability. The prime mover speed may change after loading, and the frequency may be lower than the rated frequency. The speed of the prime mover can be adjusted to the rated frequency again.

　　3.在发电机停止前，应切断负载，机器应停止无负载。

　　3. Before the generator stops, the load shall be cut off and the machine shall stop without load.

　　4.三相发电机应注意三相负荷或电流平衡，避免单相负荷运行或负荷不平衡严重使用，造成发电机组或调压器损坏。

　　4. Attention shall be paid to three-phase load or current balance of three-phase generator to avoid damage of generator set or voltage regulator caused by single-phase load operation or severe use of load imbalance.

　　以上内容是焦化发电机组厂家为您介绍使用调压器的一些注意事项，可供您在实际操作中参考。

　　The above contents are some precautions of using voltage regulator for you, which can be used for your reference in actual operation.