你好,欢迎来到济南济柴环能燃气发电设备有限公司官方网站!

瓦斯发电机组气缸套的安装步骤

来源:http://www.huannengpower.com   发布于:2016-07-09

瓦斯发电机组气缸套的安装步骤:
Installation steps of cylinder liner of gas generator set:
1.将未装橡胶封水圈的气缸套装入瓦斯发电机组机体内,在上端面用力将气缸压紧,然后用深度分厘卡尺测量气缸套上端面凸出机体顶面的距离。此距离应为0.04~0.15mm.
1. Will not fitted with rubber sealing ring of cylinder cover is sleeved into the gas turbine in the body, force in the end will be pressing cylinder, then depth points per cent caliper to measure the cylinder sleeve end surface of the convex body top surface distance. This distance should be 0.04~0.15mm.
2.检查共用一气缸盖的两个气缸套上端面凸出瓦斯发电机组机体顶面的距离相差是否在0.04mm之内,超出时应选配气缸套。
Shared stretch. Check the cylinder head of two cylinder sleeve end protruding of gas generating unit body top surface distance difference is within 0.04 mm and beyond should be equipped with a cylinder sleeve.
3.按要求装好橡胶封水圈后,将气缸套装入瓦斯发电机组机体,同时在规定的部位,分别沿曲轴中心线和垂直曲轴中心线方向测量气缸套内孔尺寸,规定内径为135mm它的圆度及其母线对内孔轴心线的平行度允差为0.015mm。
3. Installed as required sealing rubber hydrosphere, cylinder is sheathed in the gas generator set body, at the same time in the specified location, respectively, along the central line of the crankshaft and vertical crankshaft centre line direction measurement of cylinder sleeve hole size, specified inside diameter 135mm its roundness and bus and the hole axis parallelism allows poor 0.015mm.
检修发动机时,应检查瓦斯发电机组气缸体水夹层壁周围是否有穴蚀孔。对于不大的穿孔可以仔细修补,闷死,但不能使配合表面损伤和变形。同时要清理阻塞了的水、油道。
When the engine is to be inspected, the gas generator set should be checked if there is a hole in the water interlayer wall of the cylinder block of the gas generator set. Can not repair perforation carefully, suffocated, but not make with surface damage and deformation. At the same time to clean up the blocked water, oil road.

上一篇:第一页
下一篇:焦化发电机组技术特点