① 柴油不清洁，高压油管内有杂质，力出寞了喷曲器针阀偶件的磨损，使针阀偶件关闭不严，燃烧室内高压燃气反窜，烧坏针阀偶件。此外，喷油器调压弹簧、挺杆等 零件上的脏物通过喷油器挺杆移到了喷油器针阀上部，或油路上用于防止漏油的棉绳、铅丝经高压油管进入喷油器，都会使针阀偶件卡死。
The diesel is not clean, high pressure tubing has impurities, force out Mo wear curved spray nozzle, the needle valve is not tightly closed, the combustion chamber pressure gas anti channeling needle valve, burn. In addition, the injector pressure regulating spring, tappet parts such as on the dirt through the injector tappet moved to the upper part of the injector, or the oil used for cotton rope, to prevent leakage of the wire by high pressure oil into the injector, will make the needle valve stuck.
(2) the cooling of the machine with high temperature and high temperature is not good. The oil supply time is too late, the cooling water channel is too much or clogged, the end face of the pump is worn and the engine is overloaded for a long time, and the engine will overheat.
When the pumping valve is worn out, the oil drop phenomenon occurs when the injector stops injecting oil, so as to cause the coke nozzle to burn coke and accumulate coke, and the failure of card death occurs.
(4) the low pressure of the spray curve causes the anti - channeling of the high pressure gas in the combustor.
When the injector is installed, the leakage of the gasket or gasket is damaged, causing air leakage and causing excessive local temperature of the injector to die.
The parts manufacturing reasons, such as cylinder head, the fuel injector with the tight hole and the fuel injector installation hole clearance on the cover of the needle valve body and the cylinder is too small, the cylinder cover and the fuel injector hole deep processing etc..
This article will provide technical support for coking generating units. For more details, please click on our official website http://www.huannengpower.com, and we will provide you with satisfactory service.