欢迎进入济南济柴环能燃气发电设备有限公司官网!
当前位置:首页 - 新闻中心 - 发电机知识

发电机知识

什么情况下需要更换燃气发电机组的传动带

返回 2022.07.19 来源:http://www.huannengpower.com 0
相信大家都知道,作为动力传动设备——皮带,作为备件之一,燃气发电机组的使用几乎离不开这部分,它负责驱动机组风机的转动,同时也带动机组的风扇转动。充电器,使其在发电机组中。在运行期间为电池充电。功能这么多,它的使用寿命当然也在一定的时间范围内。那么,当达到这种情况时,我们需要更换它吗?
As we all know, as a power transmission equipment - belt, as one of the spare parts, the use of gas-fired generator set is almost inseparable from this part, which is responsible for driving the rotation of the fan of the unit and driving the rotation of the fan of the unit at the same time. Charger in the generator set. Charge the battery during operation. With so many functions, its service life is certainly within a certain time range. Then, when this situation is reached, do we need to replace it?
当发电机出现一些几个问题,发电机的皮带应该进行更换!
When the generator has some problems, the belt of the generator should be replaced!
1.发电机在工作时,发电机的三角度会保持一定的紧张程度,正常情况下三角带的压力会有所增加。
1. When the generator is working, the triangle of the generator will maintain a certain degree of tension, and the pressure of the triangle belt will increase under normal circumstances.
2.当三角带能按下10-20mm的距离的时候,过紧容易导致发电机、风扇和水泵的轴承磨损加剧一起故障。
2. When the V-belt can be pressed for a distance of 10-20mm, it is easy to cause the bearing wear of generator, fan and water pump to intensify and cause a fault.
3.三角度过送会导致驱动的附件达不到需要的转速,容易导致皮带出现出槽,发电机电压、风扇风量、水泵量降低,影响发电机的正常运作。
3. Over feeding of the triangle will cause the drive accessories to fail to reach the required speed, which is easy to cause the belt to slot, and the generator voltage, fan air volume and water pump volume will be reduced, affecting the normal operation of the generator.
燃气发电机组
4.一般皮带基层出现裂纹时(即皮带出现裂纹,芯部断裂,槽段开裂);带基层与槽段分离;底座磨损和破裂;松线、侧材损伤、侧硬化、侧滑、上表面裂纹);带槽段内径与带轮槽底之间无间隙。当这些情况发生时,我们需要更换皮带。
4. When cracks appear in the base course of the general belt (that is, cracks appear in the belt, the core is broken, and the groove section is cracked); The belt base is separated from the groove section; The base is worn and broken; Loose wire, side material damage, side hardening, side sliding, upper surface crack); There is no gap between the inner diameter of the groove section and the bottom of the pulley groove. When these conditions occur, we need to replace the belt.
如果不及时更换,会导致机组风扇转速过慢,导致机组散热不足导致水温偏高。当机组的某些部件出现肉眼可见的故障时,我们需要更换部件。如果不及时更换,将导致机组发生一次或多次故障。这些看似不起眼的小故障可能会导致关机。
If it is not replaced in time, the fan speed of the unit will be too slow, resulting in insufficient heat dissipation of the unit and high water temperature. When some parts of the unit have visible faults, we need to replace them. If it is not replaced in time, it will cause one or more failures of the unit. These seemingly insignificant small faults may lead to shutdown.
所以说燃气发电机使用一段时间要进行维护,对发电机皮带进行检查,如发现芯部断裂以及槽断面开裂的缺陷时,这时,我们就要立即更换。更多相关内容就来关注我们网站http://www.huannengpower.com进行咨询了解吧!
Therefore, the gas generator should be maintained for a period of time, and the generator belt should be checked. If the core is broken and the groove section is cracked, we should replace it immediately. Follow our website for more relevant content http://www.huannengpower.com Consult and understand!
新闻搜索
济南济柴环能燃气发电设备有限公司
  • 服务热线

    0531-62325028
    0531-69951266

什么情况下需要更换燃气发电机组的传动带

相信大家都知道,作为动力传动设备——皮带,作为备件之一,燃气发电机组的使用几乎离不开这部分,它负责驱动机组风机的转动,同时也带动机组的风扇转动。充电器,使其在发电机组中。在运行期间为电池充电。功能这么多,它的使用寿命当然也在一定的时间范围内。那么,当达到这种情况时,我们需要更换它吗?
As we all know, as a power transmission equipment - belt, as one of the spare parts, the use of gas-fired generator set is almost inseparable from this part, which is responsible for driving the rotation of the fan of the unit and driving the rotation of the fan of the unit at the same time. Charger in the generator set. Charge the battery during operation. With so many functions, its service life is certainly within a certain time range. Then, when this situation is reached, do we need to replace it?
当发电机出现一些几个问题,发电机的皮带应该进行更换!
When the generator has some problems, the belt of the generator should be replaced!
1.发电机在工作时,发电机的三角度会保持一定的紧张程度,正常情况下三角带的压力会有所增加。
1. When the generator is working, the triangle of the generator will maintain a certain degree of tension, and the pressure of the triangle belt will increase under normal circumstances.
2.当三角带能按下10-20mm的距离的时候,过紧容易导致发电机、风扇和水泵的轴承磨损加剧一起故障。
2. When the V-belt can be pressed for a distance of 10-20mm, it is easy to cause the bearing wear of generator, fan and water pump to intensify and cause a fault.
3.三角度过送会导致驱动的附件达不到需要的转速,容易导致皮带出现出槽,发电机电压、风扇风量、水泵量降低,影响发电机的正常运作。
3. Over feeding of the triangle will cause the drive accessories to fail to reach the required speed, which is easy to cause the belt to slot, and the generator voltage, fan air volume and water pump volume will be reduced, affecting the normal operation of the generator.
燃气发电机组
4.一般皮带基层出现裂纹时(即皮带出现裂纹,芯部断裂,槽段开裂);带基层与槽段分离;底座磨损和破裂;松线、侧材损伤、侧硬化、侧滑、上表面裂纹);带槽段内径与带轮槽底之间无间隙。当这些情况发生时,我们需要更换皮带。
4. When cracks appear in the base course of the general belt (that is, cracks appear in the belt, the core is broken, and the groove section is cracked); The belt base is separated from the groove section; The base is worn and broken; Loose wire, side material damage, side hardening, side sliding, upper surface crack); There is no gap between the inner diameter of the groove section and the bottom of the pulley groove. When these conditions occur, we need to replace the belt.
如果不及时更换,会导致机组风扇转速过慢,导致机组散热不足导致水温偏高。当机组的某些部件出现肉眼可见的故障时,我们需要更换部件。如果不及时更换,将导致机组发生一次或多次故障。这些看似不起眼的小故障可能会导致关机。
If it is not replaced in time, the fan speed of the unit will be too slow, resulting in insufficient heat dissipation of the unit and high water temperature. When some parts of the unit have visible faults, we need to replace them. If it is not replaced in time, it will cause one or more failures of the unit. These seemingly insignificant small faults may lead to shutdown.
所以说燃气发电机使用一段时间要进行维护,对发电机皮带进行检查,如发现芯部断裂以及槽断面开裂的缺陷时,这时,我们就要立即更换。更多相关内容就来关注我们网站http://www.huannengpower.com进行咨询了解吧!
Therefore, the gas generator should be maintained for a period of time, and the generator belt should be checked. If the core is broken and the groove section is cracked, we should replace it immediately. Follow our website for more relevant content http://www.huannengpower.com Consult and understand!